How To Find Fuel Gauge Fuse

How To Find Fuel Gauge Fuse, <h1>How To Find Fuel Gauge Fuse</h1> <h2>Introduction</h2> <p>Having a properly functioning fuel, blog, how-to-find-fuel-gauge-fuse, KampionLite

How To Find Fuel Gauge Fuse


Having a properly functioning fuel gauge is essential for any vehicle. It provides you with information about the amount of fuel in your tank, allowing you to know when it’s time to refuel. If your fuel gauge suddenly stops working, one of the possible causes could be a blown fuse. In this article, we will guide you on how to find the fuel gauge fuse and replace it if necessary.

Read Also :   Does A Car Alternator Work Like An AC Generator? If It’s Possible, How?

Step-by-Step Guide

Step 1: Locate the fuse box

The first step is to locate the fuse box in your vehicle. The fuse box is usually located under the dashboard near the driver’s side or in the engine compartment. Consult your vehicle’s manual for the exact location of the fuse box in your specific model and make.

Step 2: Identify the fuel gauge fuse

Once you have located the fuse box, you need to identify the fuel gauge fuse. Look for the fuse diagram on the back of the fuse box cover or in your vehicle’s manual. The fuel gauge fuse is typically labeled as “FUEL” or “GAUGE” and may be a different color than the other fuses. If you can’t find a labeled fuse, refer to the manual or use a multimeter to test each fuse individually.

Step 3: Inspect the fuse

After identifying the fuel gauge fuse, you need to inspect it to determine if it’s blown or not. A blown fuse will have a broken wire visible inside. Use a flashlight to check the fuse more easily. If the fuse appears intact, it may not be the cause of your fuel gauge problem. However, it is still worth replacing it to rule out any issues with the fuse itself.

Read Also :   Car Heater Engine Off

Step 4: Replace the fuse

If the fuel gauge fuse is blown, it needs to be replaced. Use a pair of needle-nose pliers or a fuse puller to remove the blown fuse from its socket. Make sure to remember or mark down the fuse’s amperage rating. Then, insert a new fuse with the same amperage rating into the corresponding socket. Push it in firmly to ensure a proper connection.

Step 5: Test the fuel gauge

Once you have replaced the fuse, it’s time to test the fuel gauge to see if it’s now functioning properly. Start your vehicle and observe the fuel gauge. It should display the correct fuel level based on the amount of fuel in your tank. If the gauge still doesn’t work, there may be another issue causing the problem, such as a faulty fuel sending unit or a wiring issue. Consult a mechanic for further diagnosis.

Read Also :   Can You Drive With A Clogged Injector?

Tips and Precautions

– Always consult your vehicle’s manual for specific instructions and fuse box locations.

– Make sure to use the correct amperage rating when replacing a fuse. Using a higher or lower amperage fuse can cause electrical problems or result in a blown fuse.

– If the fuel gauge fuse keeps blowing repeatedly, there may be an underlying issue that needs to be addressed. It’s advisable to seek professional help.

– Take caution when handling fuses and fuse boxes. Make sure to disconnect the vehicle’s battery before replacing fuses to avoid electrical shock.

– If you are unsure or uncomfortable with replacing fuses yourself, it’s best to have a qualified mechanic assist you.


Knowing how to find the fuel gauge fuse is essential for troubleshooting any issues with your fuel gauge. By following the step-by-step guide provided in this article, you can easily locate the fuse box, identify the fuel gauge fuse, and replace it if necessary. Remember to always use the correct amperage rating and seek professional help if needed. Maintaining a properly functioning fuel gauge ensures that you have accurate information about your fuel level, making your driving experience safer and more convenient.



Leave a Comment